The processing capacity depends on the model:
- GC-500: 5–6 tons per hour
- GC-800: 10–12 tons per hour
Yes. Actual performance depends largely on the flocculation quality of the wastewater and polymer. Larger and more stable flocs result in better dewatering efficiency. Dry cake output is approximately:
- GC-500: around 250 kg/hour
- GC-800: around 500 kg/hour
Actual results may vary depending on the thickening level in the original sludge tank.
Typical sludge cake moisture content is as follows:
- Organic sludge: 85% ± 2%
- Inorganic sludge: 80% ± 2%
The solids capture rate is typically around 90% to 95%, depending on the flocculation condition.
Suitability depends on whether the sludge can react effectively with chemicals to form flocs larger than 0.3 cm. Good flocculation is the key factor in determining machine performance.
Most filtrate is usually returned to the existing wastewater treatment system, such as the aeration tank or anaerobic tank, for further circulation and treatment.
The machine has very low power consumption, with a maximum of only 2–3 HP. At the same time, it delivers fast processing speed and automated operation, helping reduce labor costs.
Please note that the power consumption of the on-site sludge pump is calculated separately.
Yes. Polymer or flocculant is required to help the sludge form flocs larger than 0.3 cm. The standard dosage is approximately:
1 kg of chemical + 1 ton of fresh water for every 5–6 tons of raw wastewater.
The machine is built with high-quality components made in Taiwan, so replacement frequency is low. Depending on the application and industry, the most common wear parts are bearings and chains.
Yes. The machine supports automatic operation through a level control system, which starts the machine automatically when the water level reaches the preset point. It also includes automatic shutdown protection when the water level is too low.
No. Daily maintenance is simple and does not require specialized expertise. Routine maintenance mainly includes:
- Greasing the chains
- Rinsing the conveyor with fresh water after operation
This machine does not use filter cloths or screws. Maintenance is simpler because operators only need to rinse the conveyor with water. This design helps save water and eliminates the replacement cost of filter consumables.
The specifications are as follows:
- GC-500: 570 kg; 1920 mm (L) × 750 mm (W) × 2100 mm (H)
- GC-800: 760 kg; 2300 mm (L) × 1100 mm (W) × 2100 mm (H)
Yes. The piping system should include valves to control the flow rate properly during operation.
The machine is made of 304 stainless steel, providing excellent corrosion resistance for wastewater treatment environments.
Yes. Critical spare parts are kept in stock for faster service and replacement. In many cases, parts can also be sourced locally when needed.